| Switch offset |
will be on left and + on right |
| Switch elevation |
will be up and + down |
| Length at joint (setup) |
will be up and + down |
| Survey |
Setup length at joint and not at the rivet (when casting)
- Length at wet-cast – Measure length at the rivet in wet-cast when surveying
- Length at joint – Measure length at joint between wet-cast and match-cast when surveying
- Length at match-cast – Measure length at the rivet in match-cast when surveying
|
| Survey steps |
Type 1 or 2, possibility to make two surveys, the values are then taken as average of these two measurements. |
| Checksum |
Checksum of all entered values when surveying |
| Measure all at match-cast |
When not in simplified mode, it will be possible to survey all the values for match-cast and floating bulkhead not only the important ones. |
| Correction |
- Full – When correcting errors, the cast will try to return to the ideal setup.
- Parallel to casting curve – When correcting errors, new segment will be parallel to the setup casting curve.
|
| Maximum angle |
Maximum allowed correction angle when returning to ideal cast. A value of zero (0) is ignored. |
